Wiring

Firstly, a big thanks to Chris Catmull, electrical wizard, who designed the wiring system for me. Raychem type 55 double insulated airframe wire is used through out. 602 pattern military spec connectors used at all bulkheads. Raychem DR25 heat shrink. Raychem Moulded shapes and ETA circuit breaker used throughout.

Putting loom together on the wiring board.

Wiring

View looking up at ECU etc.

Wiring

View showing circuit breakers, relays, ECU etc.

Wiring

Rear bulkhead connectors.

Wiring

Two solid-state battery isolators are used. This saved having to run heavy gauge wire into the interior for the dash power kill switch. The grey box is an addition after the wiring was complete, this box controls the exhaust cooling fans and flap valves, intercooler pump etc.

Wiring